Fabricated wing wiring harnesses

Wiring harness parts

Grounding busses

Positive & Negative Busses

Added Molex pins to various lengths of cables for later electrical installations.

22 AWG, 2-conductor, shielded (Radio Shack):
(1) 18' tail-light assembly connector to inst. panel
(2) 6' stb wing-tip light connector at wing root to inst. panel
(3) 6' port wing-tip light connector at wing root to inst. panel
(4) 6' AOA vane to port wing root connector
(5) 6' AOA vane port wing connector to inst. panel (indicator)

22 AWG, 3-conductor, shielded:
(1) 4' AOA indicator (inst panel) to buses 

28 AWG, 5-conductor, shielded:
(1) 18' elevator trim servo to inst. panel & pilot stick grip

Install the Electronic Trim Servo Option (ETO)

Installed the male-end of a 5-pin waterproof connector on length of 8-wire cable and matching female-end to the 4 wires of the elevator trim servo cable. Cable connector will be located in the aft fuselage (added to aid installation/removal of h. stab & elevator structure mating to fuselage). Added the male-end of a 2-pin waterproof connector to 2 of the remaining 3 wires in the 8-wire cable and matching female-end to the 2 wires of the tail-light assembly ready for mounting in the rudder. The last wire (8th, orange) of the cable is unused. These connectors work well in marine applications and I have several more 2-pin connectors to be used in installing the wing-tip navigation/position lights, angle-of-attack sensor, fuel level transmitters, and possibly a landing light

AOA Instrument build complete

Andrew finished the AOA kit build and discussed the installation. Suggested that I seal the sensor board since it will be in the slip-stream (mounted among the port side jury strut. Purchased silicone circuit board sealer for the job.

Andrew's Electronics, andrew.kwiecinski@gmail.com  (325) 370-4404

Researched iFlyGPS iPad Air Software

Visited with Chris at iFlyGPS in McKinney. He loaded the software on my iPad Air and gave some instruction. I have a 30-day free trial period, but the application looks good for my IFR usage. The company (and Chris) were most helpful and are close by so I'll probably go with this application.

CrazedPilot nav/Pos Lights Controller Kit

LEDs & housings for lights (3D rings, circuit boards, controller). Built controller box : 7 Amp breaker, 4 mini-toggle switches, 4 mini-phono plugs, CrazedPilot Stobe/Wig-Wag controller, in 140x90x30mm plastic hobby project box for mounting under the panel.

Bad Elf GPS Antenna for iPad Air

Ordered Bad Elf external GPS antenna for iPad Air. Also bought Lightning-t--30-pin adapter ar Apple Store Willow Bend.