Sunday, March 1, 2015

Pre-Install Firewall/Nosegear Spring Assembly



Pre-Install Trial Fit Nose-Gear to Firewall
Lots of parts attach to the firewall and all seem to cross, overlay, or abut so rivet locations must be checked and adjusted against the adjoining parts. Check & double-check locations. Clecoed channel doublers (7F7-8C) in place for the steel sprig arms pin. Drilled out pin holes (5/8" dia) through both 7F7-8C doublers and the 7H7-2C channel. Located and scribed position for the steering arms pass-thru on either side of 7H7-2C. Prepared Rear (7F8-4) and Front (7F8-5) Lower Bearing plates. Nylon Lower Bearing (7H7-4C) will need to be split for mounting to the twp parts of the lower bearing plates so that the nose gear assembly can be removed.

No comments:

Post a Comment